How to Reset an SPT2 Device
Perform a hard reset on your device by holding the power button down on your device for 6-8 seconds, you will see all the lights flash from left to right when the reset is occurring.
After the reset, please go back into Bridge and erase the device. Once this is completed your device has now been reset and is ready for use
The below video demonstrates how this is done:
The steps are as follows:
- Hold on/off button down for 6-8 seconds
- Ensure all 3 LED lights activate
- Ensure all 3 LED lights flash in order (BLE, GNSS, Battery)
- Ensure all 3 LED lights flash at the same time (yellow)
If you have any further issues or concerns, feel free to submit a support ticket.